Last time in April, I introduced the V4 edition of Seamaster 007 No Time to Die that was firstly installed with the super clone 8800 movement developed by VS Factory, here is the review https://www.susanreviews.com/2025/04/21/vs-factory-v4-seamaster-007-no-time-to-die/. When this movement was firstly launched in the market, we still doubt about its stability, after several months of test and more Seamaster 300m replicas have been equipped with this super clone 8800 movement, the worry is gone, this movement should be as stable as the clone 2824 movement used in these watches before. This movement is only used in VS products, and it has some features that distinguish it from the 2824 clone movement in former Seamaster 300m, I will show you some pictures below to tell you these different features. Before that, I want to show you an update VS just made on the Seamaster 007 No Time to Die. It is on the mesh bracelet, check the pictures below.
On the bracelet, the end is a round tube before, but now the end is much wider and becomes flat. Both designs are correct.
Next, I will show you the movement difference.
If you just bought a Seamaster 300m replica watch from your dealer, he said the watch is made by VS, so what is the movement inside? The left one or the right?
Yes, the left one is the latest super clone movement developed by VS. The right one is previous movement used by them, based on a clone 2824 with extra plates.
The polishing on the movement is different, especially on the auto rotor, the polishing on the super clone 8806 is not that bright, the polishing lines are shallower now, which is closer to that of the genuine movement.
On the super clone 8806 just developed by VS, the polishing is greatly improved.
On previous movement based on a common Chinese movement, the polishing on the movement looks too bright, and the polishing lines on the rotor are too deep.
On the latest super clone movement, this place is a big difference between it and the genuine movement, it has one extra regulator. So if the Seamaster 300m has a see-through case back, it is easily for someone to tell this is a fake watch if he has some knowledge about the Omega movement.
There is a central pivot inside each jewel.
Fake jewels on previous movement, also without arbor.
On the new super clone movement, the engraving in this place is thicker and more clear.
On the old movement, that engraving is smaller and looks blurred.
Do you notice this hole on the movement plate? When you winding the watch, please observe this hole, the gear inside will move on the new super clone movement. It does not move on the old movement.
At last, the new super clone movement has a power reserve of about 50 hours, the old movement has a power reserve of about 40 hours. Both movements have a good stability.
Here are the Omega Seamaster replicas with the new super clone movement.
